1 comment / Posted on by bilal mahmood

Basic set up guide to using your cloud chaser or other dripper kit!

 

1- Make sure the airflow holes are directly in front of your coil! This will give you the best vape and is very important!

2- All mech mods like the cronus and Castle mod can be adjusted, they have adjustable pins and switches, simply undo them and adjust to however you like. For example on the castle mod undo the pin in the top cap, and screw your atomizer all the way in so it sits flush, then screw the pin back in till it makes contact and unscrew the smaller screw to make contact with the battery. similarly undo the pin on the inside of the switch to adjust the throw, tighter is less throw, loose is more throw!

3- Make sure your coils always have plenty of juice!

4- Cotton wool can be changed very easily and should be done often to keep the flavour fresh, just gently slide out the old pieces and slide in some fresh wool.

5- Battery always goes in positive toward the atomizer and negative towards the switch.

6- If you ever get a short and your battery heats up, throw the battery away! Take your coils out and start again!

7-Dont over discharge your battery! Once you feel the voltage drop, change the battery and charge!

8- Don't go too low, if you don't know the amp rating of your battery then don't sub-ohm, the lowest you can safely take a 35amp battery is around 0.4 ohms and regular efest is at around 0.7 ohms.

9- If you dont have a clue what your doing and are not willing to research and learn, then give up your gear and buy a starter kit!

10- Make sure you have an ohms reader, and use it!

11- Sub ohming can be dangerous! Be careful and don't do anything stupid! Check your coils and your resistance!

Basic set up guide to using your cloud chaser or other dripper kit!

 

1- Make sure the airflow holes are directly in front of your coil! This will give you the best vape and is very important!

2- All mech mods like the cronus and Castle mod can be adjusted, they have adjustable pins and switches, simply undo them and adjust to however you like. For example on the castle mod undo the pin in the top cap, and screw your atomizer all the way in so it sits flush, then screw the pin back in till it makes contact and unscrew the smaller screw to make contact with the battery. similarly undo the pin on the inside of the switch to adjust the throw, tighter is less throw, loose is more throw!

3- Make sure your coils always have plenty of juice!

4- Cotton wool can be changed very easily and should be done often to keep the flavour fresh, just gently slide out the old pieces and slide in some fresh wool.

5- Battery always goes in positive toward the atomizer and negative towards the switch.

6- If you ever get a short and your battery heats up, throw the battery away! Take your coils out and start again!

7-Dont over discharge your battery! Once you feel the voltage drop, change the battery and charge!

8- Don't go too low, if you don't know the amp rating of your battery then don't sub-ohm, the lowest you can safely take a 35amp battery is around 0.4 ohms and regular efest is at around 0.7 ohms.

9- If you dont have a clue what your doing and are not willing to research and learn, then give up your gear and buy a starter kit!

10- Make sure you have an ohms reader, and use it!

11- Sub ohming can be dangerous! Be careful and don't do anything stupid! Check your coils and your resistance!

1 comment

  • Posted on by 1

    1

Leave a comment

All blog comments are checked prior to publishing